Industrial Cards - Tanya Heritage

Hello...
 
Time to share another DT post for Paper Rose Studio.
I've used some papers from the Industrial A5 paper collection.
The papers are perfect for male cards. One of the cards I have 
made is a shaker card, the other card I have made using some of 
the left over paper bits from the dies cuts on the shaker card.
 
To make the shaker card I have die cut out five pieces using the  
21441 Paper Piece Rectangle die. Four are from black cardstock 
and the top piece is from the 19181 Industrial A5 Paper Collection.
I have glued the black frame pieces together then I added a piece of 
clear acetate to the top of the black frame pieces. 
 
The top piece is patterned paper from the industrial paper 
collection. I have taped some of the die cut out pieces back into 
their spaces in the frame. Turning the frame upside down I added 
some gems from the 18942 Gem Flakes Shaker Mix and added a piece 
of black cardstock over the top to hold them all in place. 
 
To finish the front of the card off I fussy cut a few pieces 
from one of the papers in the paper collection. I have die cut 
some cogs out of silver cardstock using the 17868 Cog Frame Die.
The sentiment is done using 19023 Black & White Sentiments and 
 
When putting the card together I have die cut out the silver 
cardstock using 16575 Stitched Frames die. Layer a bigger piece of black cardstock then attach to the white card base.
 
 
 
For this card I have used all the same things as in the above card. 
I have die cut out some cogs from blue cardstock to add some 
colour to the card. 
The sentiment is die cut from the 

Leave a comment

Please note, comments must be approved before they are published